Running Parameter Sweep AnalysisĬonsider the series RLC circuit shown in Figure 1. For example the inductance is the only parameter available for an inductor as compared to a diode model that contains approximately 15 to 25 parameters. Active components such as op-amps, transistors, diodes and others will have more parameters available to perform a sweep than passive component such as resistors, inductors and capacitors. This will depend on the model of the component. You will find that some components have more parameters that can be varied than others. There are three types of analysis that can be performed on the circuit while the component is manipulated: DC Operating Point, Transient Analysis and AC Analysis. You control the parameter values by choosing a start value, end value, type of sweep that you wish to simulate and the desired increment value. The effect is the same as simulating the circuit several times, once for each value. With Parameter Sweep Analysis, you can verify the operation of a circuit by simulation across a range of values for a component parameter. The behavior of a circuit is affected when certain parameters in specific components change.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |